| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE POWER CORD FROM THE CORD HOOK.
|
| 2 |
|
UNHOOK THE VAC HOSE FROM THE HOSE HOOK.
|
| 3 |
|
LOCATE THE BUTTON ON THE BACK OF THE MACHINE. SLIDE THE BUTTON TO OPEN.
|
| 4 |
|
LIFT UP ON THE UPPER ASSEMBLY TO REMOVE IT FROM THE BASE.
|
| 5 |
|
SLIDE UP ON THE BAG COVER LATCH. PULL THE BAG COVER FROM THE MACHINE.
|
| 6 |
|
PUSH IN ON THE RED LEVER ON THE RIGHT SIDE TO UNLOCK THE BAG.
|
| 7 |
|
PULL THE BAG DOWN OFF THE INTAKE HOSE.
|
| 8 |
|
REMOVE THE 4 SCREWS HOLDING THE UPPER BAG HOUSING.
| Screwdriver-phillips |
|
|
| 9 |
|
PULL THE UPPER BAG HOUSING UP TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 10 |
|
REMOVE THE 4 SCREWS FROM THE LOWER VAC HOUSING. PULL THE BASE PLUG OUT OF MACHINE.
| Screwdriver-phillips |
|
|
| 11 |
|
PULL UP ON THE TOP OF THE LOWER VAC HOUSING TO SEPARATE IT FROM THE VAC MOTOR HOUSING.
|
| 12 |
|
REMOVE 1 SCREW HOLDING HOSE SUPPORT TO THE VAC MOTOR HOUSING.
| Screwdriver-phillips |
|
|
| 13 |
|
PULL TO REMOVE HOSE SUPPORT.
|
| 14 |
|
LOCATE THE CURVE SUPPORT IN THE VAC MOTOR HOUSING.
|
| 15 |
|
REMOVE THE 2 SCREWS HOLDING THE CURVE SUPPORT TO VAC MOTOR HOUSING.
| Screwdriver-phillips |
|
|
| 16 |
|
REMOVE CURVE SUPPORT FROM MACHINE AND PULL THE HOSE APART TO SEPARATE THE 2 PIECES.
|
| 17 |
|
PULL THE BOTTOM HOSE AWAY FROM CURVE SUPPORT.
|
| 18 |
|
LOCATE THE TERMINAL BLOCK ON THE LOWER VAC HOUSING. LOOSEN THE 3 SCREWS ON THE RIGHT SIDE (SIDE CLOSEST TO VAC MOTOR) OF TERMINAL BLOCK. PULL TO REMOVE THE WIRES FROM THE TERMINAL BLOCK.
| Screwdriver-flat tip |
|
|
| 19 |
|
DISCONNECT THE 3 WIRES FROM THE VAC MOTOR. 1 GREEN/YELLOW AND 2 BLUE WIRES.
|
| 20 |
|
LINE THE CARBON BRUSHES UP WITH NOTCHES IN THE VAC HOUSING.
|
| 22 |
|
SLIDE THE VAC MOTOR OUT OF THE VAC HOUSING. REVERSE STEPS 1 THRU 21 TO INSTALL A NEW VAC MOTOR AND TO REASSEMBLE THE MACHINE.
|